Affirmative 7370 User Guide
the Z-Com card, it will often happen automatically, but sometimes you may have to execute the
following procedure:
following procedure:
a. The PRISMNDS1 window will appear. Status should read “Not Connected”, and
Signal Strength should read “No Signal”. Follow this procedure:
b. Highlight the desired network name (SSID) in the box.
c. Click
c. Click
on
Connect. The Wireless Network Properties box will appear.
d. If you want to make any changes from the previous properties, make them here. See
for configuration information.
e. Click
on
OK. You will return to the PRISMNDS1 window.
f. After several seconds, there should now be some Signal Strength reading if an access
point is available, and the Status should first read “Scanning”, then “Associating with
xxx” and finally “Connected to xxx”.
xxx” and finally “Connected to xxx”.
g. The 7370 can now communicate on the xxx network.
Note: Occasionally, the Status will never advance past “Associating with xxx”. In this
case, you will have to do a Cold Boot again.
Note: Occasionally, the Status will never advance past “Associating with xxx”. In this
case, you will have to do a Cold Boot again.
7. Choose one of the YESterm Administrator options or close this window and double-click on any of
the displayed icons on the Desktop to activate the corresponding application.
Resume
1. Push briefly on the Suspend button.
2. Within several seconds, you should return to the same screen that was displayed at the time that the
2. Within several seconds, you should return to the same screen that was displayed at the time that the
Suspend mode was invoked.
3. If you were previously connected to an access point, the wireless LAN adapter will automatically
reconnect to the access point in 10-20 seconds.
4. You can continue operation from the same point at which you entered the Suspend mode.
Reset/Power Off
The Reset button (
) resides in a small cavity at the back of the YEStablet 7370. Use a fine-
tip instrument, such as the stylus, to operate this button. You may use the Reset button to perform a
Cold Reboot on the YEStablet 7370 in the unlikely event of device lock. To execute, push on the
button for over 4 seconds to activate the Reset or Power Off. The 7370 will be turned completely off,
and you will need to restart the device by pushing briefly on the button again. This Reset/Power Off
operation will clear any software settings and information not saved to flash memory.
Note: If the battery becomes completely drained while the 7370 is disengaged from an external power
source, a Reset/Power Off will be automatically executed.
Cold Reboot on the YEStablet 7370 in the unlikely event of device lock. To execute, push on the
button for over 4 seconds to activate the Reset or Power Off. The 7370 will be turned completely off,
and you will need to restart the device by pushing briefly on the button again. This Reset/Power Off
operation will clear any software settings and information not saved to flash memory.
Note: If the battery becomes completely drained while the 7370 is disengaged from an external power
source, a Reset/Power Off will be automatically executed.
Suspend/Resume
The Suspend button (
) is the slightly recessed button along the left edge when facing the
device. A quick push of the button toggles between Suspend and Resume – with enough intervening
lapse. The machine cannot enter into Suspend mode again within 15 seconds after Resuming. This is
lapse. The machine cannot enter into Suspend mode again within 15 seconds after Resuming. This is
36