SATO MB410i User Guide
Unit 3: Setup
Page 3-12
PN 9001190C
MB400i/MB410i Operator Manual
LOADING THE LABEL ROLL (CONTINUOUS MODE)
The method of installing label media varies with your choice of the two possible print modes—
continuous or dispense mode.
continuous or dispense mode.
Figure 3-12, Continuous Mode
Figure 3-13, Sliding Dispenser Unit Down
1. Make sure you can see the red platen roller. If not, slide the dispenser unit down, by lifting
its top edge (Tear-off bar) upwards at the two arrow marks. Now push the dark gray Cover
Open/Close lever downwards to release the cover.
Open/Close lever downwards to release the cover.
Figure 3-14, Adjusting Label Guide Stopper
2. While pressing the label guide stopper, slide the label guide to the width of the label roll
being loaded. (Note the measurement on the inside of printer.)
Continuous mode
Label
Journal paper/
Linerless label
Linerless label
Dispenser unit
Label guide stopper