Revel sub15 User Guide

Page of 39
AUTOMATIC MUSIC SENSOR
The ULTIMA LE-1 is equipped with a power management system
called Automatic Music Sensor. In the default mode, internal 
circuits continually sense the inputs for presence of audio signals.
When detected, the ULTIMA LE-1’s power supply will be automati-
cally turned on. When audio signals are absent for approximately 25
minutes, the Automatic Music Sensor instructs the power supply to
revert to the standby mode to conserve power. You can control the
Automatic Music Sensor by performing the steps below:
1. On the ULTIMA LE-1 front panel, press POWER to apply full
power to the unit. Wait approximately 10 seconds for the LE-1
to switch into its full operating mode. 
2. On the ULTIMA LE-1 rear panel (refer to Figure 7 on page
14), locate the MUSIC SENSOR BYPASS switch.
3. Press and hold the switch for at least 5 seconds to bypass (or
enable) Automatic Music Sensor. When the ULTIMA LE-1 is
in standby mode, the front panel LED display will indicate
three horizontal dashes when Automatic Music Sensor is
bypassed, and one dash when it is enabled.
NOTE: In this mode, when this feature is bypassed, you can use the
front panel POWER control to turn the ULTIMA LE-1 on and off,
or use trigger control (see “Triggered Power Control” on page 29, or
also see “Front Panel Layout” on page 13). The ULTIMA LE-1 will
remember bypass (or enable) settings each time it is turned on (i.e.,
each repetition of Step 3 will cause Automatic Music Sensor mode to
alternate between enabled and bypassed).
ULTIMA SUB-15/LE-1
Owner’s Manual
28