Whirlpool WGD7300X User Manual
14
Stains on load or drum
■
Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue
jeans). This will not transfer to other clothing.
jeans). This will not transfer to other clothing.
Loads are wrinkled
■
Was the load removed from dryer at the end of the cycle?
For Steam Dryers select Enhanced Touch Up Cycle to tumble
the load with water and heat to help smooth out wrinkles from
a load left in the dryer.
the load with water and heat to help smooth out wrinkles from
a load left in the dryer.
■
Was the dryer overloaded?
Dry smaller loads that can tumble freely. Smaller loads of one
to four garments yield best results with Quick Refresh Cycle.
Results may also vary depending on fabric type. This cycle is
best for reducing wrinkles and odors from loads consisting of
wrinkle-free cotton, cotton polyester blends, common knits,
and synthetics.
to four garments yield best results with Quick Refresh Cycle.
Results may also vary depending on fabric type. This cycle is
best for reducing wrinkles and odors from loads consisting of
wrinkle-free cotton, cotton polyester blends, common knits,
and synthetics.
■
Loads are still wrinkled following Steam cycle on Steam
models?
models?
Make sure water is connected to the dryer. Check that water
inlet hose is connected to both the faucet and dryer’s water
inlet valve. Check that the water supply is turned on. This
cycle is best for smoothing out wrinkles and reducing odors
from loads consisting of wrinkle-free cotton, cotton polyester
blends, common knits, and synthetic garments.
inlet hose is connected to both the faucet and dryer’s water
inlet valve. Check that the water supply is turned on. This
cycle is best for smoothing out wrinkles and reducing odors
from loads consisting of wrinkle-free cotton, cotton polyester
blends, common knits, and synthetic garments.
NOTE: Refer to garment care label instructions. Dry clean only
garments are not recommended.
garments are not recommended.
Odors
■
Have you recently been painting, staining, or varnishing in
the area where your dryer is located?
the area where your dryer is located?
If so, ventilate the area. When the odors or fumes are gone
from the area, rewash and dry the clothing.
from the area, rewash and dry the clothing.
■
Is the dryer being used for the first time?
The new electric heating element may have an odor. The odor
will be gone after the first cycle.
will be gone after the first cycle.
■
Is water connected to the dryer for Steam models?
Check that water inlet hose is connected to both the faucet
and dryer’s water inlet valve. Check that the water supply is
turned on.
and dryer’s water inlet valve. Check that the water supply is
turned on.
■
To remove odors left in garments after wearing, select Steam
Cycle. These cycles are best for reducing odors from loads
consisting of wrinkle-free cotton, cotton polyester blends,
common knits, and synthetics.
Cycle. These cycles are best for reducing odors from loads
consisting of wrinkle-free cotton, cotton polyester blends,
common knits, and synthetics.