Bunn single tf brewwise dbc Operating Guide

Page 9

CAUTION – The brewer must be disconnected from the power source throughout the initial setup, except when 

specified in the instructions.

1.  Insert an empty funnel into the funnel rails of the brew station.

2.  Place an empty server under the funnel.

3.  Connect the brewer to the power source.  Water will begin flowing into the tank and stop when the tank is 

filled to its capacity. Display will show PLEASE WAIT...TANK FILLING until tank is filled with water.

4.  Wait approximately 20 mins for the water in the tank to heat to the proper temperature on 120V/208V ma-

chines. (Wait approximately 45 mins on 120V machines). Display will show READY TO BREW...WATER 

TEMP: XXX˚ when tank is at operating temperature.

5.  Place a small vessel beneath the faucet and open the faucet handle. Release it when you hear the tank refill-

ing.

6.  Water volumes have been preset at the factory. Refer to adjustments for the Set Brew Volumes section of 

this manual should the volume need to be increased or decreased.

7.  The brewer is now ready for use in accordance with the coffee brewing instructions.

1.  Insert a BUNN filter into the Smart Funnel.

2.  If a grinder is not used to obtain the coffee grounds, pour the proper amount of fresh coffee grounds into 

the funnel and level by gently shaking. Slide the funnel into the funnel rails and select batch size. Proceed to 

step 5.

3.  If a G9-2T DBC or MHG grinder is used with a compatible Smart Funnel, select the desired batch size on the 

grinder. Grind the selected amount of fresh coffee into funnel and level grounds by gently shaking. It is not 

necessary to select a size on the brewer.  

4.  Slide the funnel into the funnel rails. The brewer will read the size ground through the chip in the funnel 

handle and will automatically select the correct size to brew.

5.  Place an empty server under the funnel.

6  The ENABLE BREW switch must be ON (indicator lit). Momentarily press and release the BREW switch.  If 

the brewer has the funnel lock option and if it is activated, once a brew cycle has been started the funnel is 

locked in place. There may be certain situations in which the brew cycle will not begin when BREW switch 

is pressed:

 

a)   ENABLE BREW must be ON.

 

b)  BREW TEMPERATURE TOO LOW - wait until heated or cancel BREW LOCKOUT option.

 

c)   FUNNEL NOT IN PLACE (or using a standard brew funnel) - cancel FUNNEL DETECT.

 

d)  CHECK FUNNEL - remove funnel, empty previously brewed grounds and grind a new batch into the fun-

nel.

7.  If none of the above messages are displayed, the display will read NOW BREWING and the time remaining 

in the brew cycle.

8.  Following the BREW will be a countdown DRIPPING time which shows the time remaining until the funnel 

lock will release. Discard the grounds and filter only after visible dripping stops.

35879.1 062107