KitchenAid 30'' Slow Cook Warming Drawer Installation Guide

IMPORTANT: The warming drawer must be electrically grounded 

in accordance with local codes and ordinances, or in the 

absence of local codes, with the National Electrical Code, ANSI/

NFPA 70 or Canadian Electrical Code, CSA C22.1.
If codes permit and a separate ground wire is used, it is 

recommended that a qualified electrical installer determine that 

the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association  

1 Batterymarch Park 

Quincy, MA 02169-7471

CSA International 

8501 East Pleasant Valley Road 

Cleveland, OH 44131-5575

 

■

A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit 

is required. A time-delay fuse or circuit breaker is also 

recommended. It is recommended that a separate circuit 

serving only this warming drawer be provided.

 

■

The model/serial/rating plate is located above the left-hand 

side receiving slide. The warming drawer must be removed 

to view the model/serial/rating plate. See the illustration 

below.

1.  Turn off power supply. Using 2 or more people, move 

warming drawer close to its final location. Remove and 

discard shipping materials, tape, and film from the warming 

drawer. Remove and set aside racks and other parts from 

inside warming drawer.

2.  Check that the warming drawer Temperature control knob 

is set to the OFF position.

3.  Support the warming drawer on a sturdy surface level with 

the cutout opening.

4.  Plug the power supply cord into the grounded 3 prong outlet.
5.  Slide the warming drawer over halfway into the cutout 

opening.

6.  Open warming drawer and slowly push against the front 

panel to slide the drawer completely into the cabinet until 

the flanges on the front panel meet the cabinet face.