Netgear M5300-28G3 (GSM7328Sv2h2) - ProSAFE 24+4 Gigabit Ethernet L3 Managed Stackable Switch Software Guide
Quality of Service Commands
1088
M5300, M6100, and M7100 Series ProSAFE Managed Switches
no ipv6 access-list
This command deletes the IPv6 ACL identified by name from the system.
ipv6 access-list rename
This command changes the name of an IPv6 ACL. The name parameter is the name of an
existing IPv6 ACL. The newname parameter is a case-sensitive alphanumeric string from 1 to
31 characters uniquely identifying the IPv6 access list.
existing IPv6 ACL. The newname parameter is a case-sensitive alphanumeric string from 1 to
31 characters uniquely identifying the IPv6 access list.
This command fails is an IPv6 ACL by the name that is specified by the newname argument
already exists.
already exists.
{deny | permit} (IPv6)
This command creates a new rule for the current IPv6 access list. Each rule is appended to
the list of configured rules for the list. A rule may either deny or permit traffic according to the
specified classification fields. At a minimum, either the every keyword or the protocol,
source address, and destination address values must be specified. The source and
destination IPv6 address fields may be specified using the keyword any to indicate a match
on any value in that field. The remaining command parameters are all optional, but the most
frequently used parameters appear in the same relative order as shown in the command
format.
the list of configured rules for the list. A rule may either deny or permit traffic according to the
specified classification fields. At a minimum, either the every keyword or the protocol,
source address, and destination address values must be specified. The source and
destination IPv6 address fields may be specified using the keyword any to indicate a match
on any value in that field. The remaining command parameters are all optional, but the most
frequently used parameters appear in the same relative order as shown in the command
format.
Note:
The no form of this command is not supported, since the rules within
an IPv6 ACL cannot be deleted individually. Rather, the entire IPv6
an IPv6 ACL cannot be deleted individually. Rather, the entire IPv6
ACL must be deleted and respecified.
Format
no ipv6 access-list name
Mode
Global Config
Format
ipv6 access-list rename name newname
Mode
Global Config
Format
{deny | permit} {every | {{icmpv6 | ipv6 | tcp | udp | 0-255}
{source-ipv6-prefix/prefix-length | any | host source-ipv6-address} [eq
{portkey | 0-65535}] {destination-ipv6-prefix/prefix-length | any | host
destination-ipv6-address} [eq {portkey | 0-65535}] [flag [+fin | -fin] [+syn
| -syn] [+rst | -rst] [+psh | -psh] [+ack | -ack] [+urg | -urg]
[established]] [flow-label value] [icmp-type icmp-type [icmp-code icmp-code]
| icmp-message icmp-message] [routing] [fragments] [dscp dscp]}} [log]
[assign-queue queue-id] [{mirror | redirect} unit/slot/port] [rate-limit rate
burst-size]
Mode
IPv6-Access-List Config