Netgear M5300-28G3 (GSM7328Sv2h2) - ProSAFE 24+4 Gigabit Ethernet L3 Managed Stackable Switch Software Guide

This section describes the commands you use to configure IPv6 Access Control List (ACL) 
settings. IPv6 ACLs ensure that only authorized users have access to specific resources and 
block any unwarranted attempts to reach network resources. 

The following rules apply to IPv6 ACLs:

The maximum number of ACLs you create is 100, regardless of type.

The system supports only Ethernet II frame types.

The maximum number of rules per IPv6 ACL is hardware dependent.

This command creates an IPv6 Access Control List (ACL) identified by name, consisting of 
classification fields defined for the IP header of an IPv6 frame. The name parameter is a 
case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IPv6 
access list. The rate-limit attribute configures the committed rate and the committed burst 
size.

If an IPv6 ACL by this name already exists, this command enters IPv6-Access-List config 
mode to allow updating the existing IPv6 ACL.

The CLI mode changes to IPv6-Access-List Config mode when you 
successfully execute this command.

ACL Type

Type of access list (IP, IPv6, or MAC).

ACL ID

Access List name for a MAC or IPv6 access list or the numeric identifier for an IP access list.

Sequence Number

A sequence number indicates the order of the access list relative to other access lists already 

assigned to this interface and direction.

in or out

in – Display Access List information for a particular interface and the in direction.

out – Display Access List information for a particular interface and the out direction.

Format

ipv6 access-list name

Mode

Global Config