Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Software Guide

IPv6 management commands allow a device to be managed via an IPv6 address in a switch 
or through IPv4 routing (that is, independent from the IPv6 routing package). For 
Routing/IPv6 builds of NETGEAR Managed Switch software, dual IPv4/IPv6 operation over 
the service port is enabled. NETGEAR Managed Switch software has capabilities such as:

Static assignment of IPv6 addresses and gateways for the service/network ports.

The ability to ping an IPv6 link-local address over the service/network port.

Using IPv6 management commands, you can send SNMP traps and queries via the 
service/network port.

The user can manage a device via the network port (in addition to a Routing Interface or 
the Service port). 

Use this command to enable IPv6 operation on the service port. By default, IPv6 operation is 
enabled on the service port.

This command is supported on M6100 series switches only

Use this command to disable IPv6 operation on the service port.

Use the options of this command to manually configure IPv6 global address, enable/disable 
stateless global address autoconfiguration and to enable/disable dhcpv6 client protocol 
information on the service port.

Multiple IPv6 prefixes can be configured on the service port.

Default

enabled

Format

serviceport ipv6 enable

Mode

Privileged EXEC

Format

no serviceport ipv6 enable

Mode

Privileged EXEC