Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Software Guide
IPv6 Commands
925
M5300, M6100, and M7100 Series ProSAFE Managed Switches
Note:
This command is supported on M6100 series switches only
no serviceport ipv6 gateway
Use this command to remove IPv6 gateways on the service port interface.
serviceport ipv6 neighbor
Use this command to manually add IPv6 neighbors to the IPv6 neighbor table for the service
port. If an IPv6 neighbor already exists in the neighbor table, the entry is automatically
converted to a static entry. Static entries are not modified by the neighbor discovery process.
They are, however, treated the same for IPv6 forwarding. Static IPv6 neighbor entries are
applied to the hardware when the corresponding interface is operationally active.
port. If an IPv6 neighbor already exists in the neighbor table, the entry is automatically
converted to a static entry. Static entries are not modified by the neighbor discovery process.
They are, however, treated the same for IPv6 forwarding. Static IPv6 neighbor entries are
applied to the hardware when the corresponding interface is operationally active.
Note:
This command is supported on M6100 series switches only
no serviceport ipv6 neighbor
Use this command to remove IPv6 neighbors from the IPv6 neighbor table for the service
port.
port.
Format
serviceport ipv6 gateway gateway-address
Mode
Privileged EXEC
Parameter
Description
gateway-address
Gateway address in IPv6 global or link-local address format.
Format
no serviceport ipv6 gateway
Mode
Privileged EXEC
Format
serviceport ipv6 neighbor ipv6-address macaddr
Mode
Privileged EXEC
Parameter
Description
ipv6-address
The IPv6 address of the neighbor or interface.
macaddr
The link-layer address.
Format
no serviceport ipv6 neighbor ipv6-address macaddr
Mode
Privileged EXEC