Netgear XS716E – ProSAFE® 10-Gigabit Ethernet Web Managed (Plus) Switch User Manual

Enter the switch’s password in the password field.

The switch’s default password is password.

The Switch Status page displays.

Select System > Multicast.

Make sure that the IGMP Snooping Status Enable radio button is selected.

In the VLAN ID Enabled for IGMP Snooping field, enter the ID of the VLAN.

By default, if you enable IGMP snooping, snooping occurs on VLAN 1. However, you can 
enable snooping on any VLAN:

For port-based VLANs, you can enter a VLAN ID from 1 to 8 or 1 to 16, depending on 
the switch model.

For 802.1Q-based VLANs, you can enter a VLAN ID from 1 to 4094.

Click the APPLY button.

Your settings are saved.

Link aggregation groups (LAGs) allow you to combine multiple Ethernet links into a single 
logical link. Network devices treat the aggregation as if it were a single link, which increases 
fault tolerance and load sharing. The switch supports up to four static LAGs. Configure LAG 
membership before you enable the LAG.

The switch does not support IEEE 802.3ad Link Aggregation or Link 

Aggregation Control Protocol (LACP) groups. The switch supports 

manual static LAGs only.