buell s1 lightning '97 Manual

1.

If necessary, cut any surrounding cable straps to gain
access to the connector.

2.

 Depress the button on the socket termi-

nal side of the connector (plug) and pull apart the pin and
socket halves. 

3.

Bend back the latch slightly and free one side of second-
ary lock, then repeat the step to release the other side.
Rotate the secondary lock outward on hinge to access
terminals in chambers of connector housing.

4.

Looking in the terminal side of the connector (opposite
the secondary lock), take note of the cavity next to each
terminal.

5.

 With the flat edge against the terminal,

insert the pick (Snap-On TT600-3) into the cavity until it

stops. Pivot the end of the pick away from the terminal

and gently tug on wire to pull terminal from chamber. Do

not tug on the wire until the tang is released or the termi-

nal will be difficult to remove. A “click” is heard if the tang

is engaged but then inadvertently released. Repeat the

step without releasing the tang. 

NOTE

used to install Amp Multilock pin and socket terminals on
wires. If new terminals must be installed, see 

.

f1292x2x