Autostart as-6070 tw User Manual

of vehicles could cause them to remain

 even after remote starter shut down, resulting in a dead

battery.

Driving Off 
With the vehicle running under remote control, press the

 button to disarm and unlock the

doors. Enter the vehicle and do the following:
x

Turn the ignition key to the 

 position. (Do not turn the key to the 

position while the engine is running. This would cause the starter motor to re-engage.)

x

Press the brake pedal to disengage the remote starter unit.

You are now ready to drive off.

Arming and Disarming the System 

To disarm the alarm and Starter Kill (if installed) and unlock the doors (if installed):
1.

Press and hold the

 button for approx. 1 sec.

You will hear two chirps if the Siren or Horn is so configured.

2.

The  icon will light up on the LCD display of the remote control. The parking lights will flash
twice and the L.E.D. will go out to confirm that the doors have been unlocked and that the
Starter Kill (if installed) and the alarm are disarmed.

In Passive Mode, the System will rearm automatically 30 seconds after unlocking unless the key is
meanwhile inserted in the ignition switch (see description of Passive Mode later in this Guide).

To arm the alarm and Starter Kill (if installed) and lock the doors (if installed):
1.

Press and hold the

 button for approx. 1 sec.

You will hear one chirp if the Siren or Horn is so configured.

2.

The

icon will light up on the LCD display of the remote control. The parking lights will flash

once and the L.E.D. will flash slowly to confirm that the doors have been locked and that the
Starter Kill feature (if installed) and the alarm are armed.

Idle Mode 

Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.

This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a conveni-
ence store, lock your vehicle and leave it running for the length of a run cycle while you are away.
Idle Mode can be activated through the same routine as that used for Ready Mode; at the last step,
the

 button is pressed instead of the other buttons:

1.

Ensure that all the Doors are closed and that the Shifter is in the Neutral position.

2.

With the Engine already running, apply the Parking Brake and release the Brake Pedal.
Make sure to release the brake pedal.

3.

Within 20 sec. push

,

 or 

 on the Transmitter.

4.

Remove the key: the Engine will go on running.

5.

Exit the vehicle and close the Door.

6.

Press the 

button until the system is armed (the doors will be locked if remote

door lock is installed).

If the pre-programmed run-time expires or if the user shuts down the engine by remote control, the
vehicle will get in Ready Mode.

P. 10 

User Guide

 AS-6070 TW