Autostart as-6070 tw User Manual

AS-6070 TW User Guide

P. 9

To set the system to Ready Mode: 
1.

Ensure that all the doors are closed and that the shifter is in the neutral position. 

2.

With the engine already running, apply the parking brake and release the brake pedal. 
Make sure to release the brake pedal. 

3.

Within 20 sec. press 

,

 or 

 on the transmitter. 

4.

Remove the key: the engine will go on running. 

5.

Exit the vehicle and close the door. 

6.

Press and hold either: 
a.

 to lock the doors and shut down the engine; 

b.

 to unlock the doors and shut down the engine; 

c.

 to shut down the engine without affecting the doors. 

Remaining In Ready Mode 
Once the vehicle is in Ready Mode you can start and stop the vehicle at wish. However, should 
any of the following occur, the vehicle will exit Ready Mode – thus eliminating the remote start 
option until Ready Mode is restored: 

x Door opened; 
x Hood opened; 
x Brake pedal pressed; 
x Parking brake disengaged; 
x Ignition key turned to the 

 position. 

Should any of the above occur, Ready Mode will be cancelled. 

Note: The unit will notify the user that it has exited Ready Mode by giving 3 slow flashes 
(parking lights). 

Remote-starting
Press the 

 button for approx. 1 second. The parking lights will come 

 and the remote 

control will play a melody to inform you that the System has received your signal. Approximately 5 
seconds later, the engine will start. The remote control will play a second melody to confirm that 
the vehicle was successfully started. The parking lights will remain 

 during the pre-programmed 

run time of the engine. 

Be careful! It could take up to 10 seconds before you receive the second confirmation 
(Runtime).  If you press any buttons before that, you will not receive the second confirmation. 

If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and 
try to start the engine again. There will be 3 start attempts before the system gives up. 

Once the vehicle is running, the user may select the length of time during which the engine is to go 
on running. 

Vehicle Presets 

Heater & Heated Seat 
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the 
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if 
equipped) should not be left on 

. It is recommended to leave the settings on 

 or 

instead. 

Windshield Wipers & Radio & Headlights 
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become 
energized while running under remote start. When leaving the vehicle you must ensure that the 
windshield wiper and headlight switches are 

. Leaving the headlight switch 

 on certain types