Alliance Laundry Systems D715I User Manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

510963

16

The dryer can be installed in a manufactured (mobile) 
home by following these instructions:

1. IMPORTANT: Gas dryers MUST be 

2. Electrical Connections (Electric Dryer Only) 

must be a 4-wire connection, refer to page 19.

3. Venting – Dryer MUST be exhausted to the 

outdoors.

●

The dryer can be exhausted to the outdoors 
through the back, left, right or bottom panel. Gas 
dryers cannot be exhausted out the left side 
because of the burner housing.

●

The dryer exhaust duct must be secured to the 
mobile home structure.

●

Exhaust ducts MUST NOT be connected with 
sheet metal screws or fasteners which extend into 
the duct.

●

Exhaust duct must not be connected to any other 
duct, vent or chimney.

●

Dryer exhaust duct MUST NOT terminate under 
the mobile home.

●

For proper operation, it is important that the dryer 
has an ample amount of outside make-up air. The 
free area of any opening for the introduction of 
outside air must be at least 25 in

2

 (163 cm

2

).

●

When exhausting the dryer to the outdoors, the 
dryer can be installed with “0” inch clearance at 
the sides and rear. Clearance of the duct from 
combustible construction must be a minimum of 
2 inches (5.08 cm).

●

Venting materials are not supplied with the dryer 
(obtain locally).

W047

W048