bobcat s205 User Manual

Open the rear door and remove the rear grill.

Remove the coolant fill cap (1) [Figure 149].

Connect a hose to the engine block drain valve (2)
[Figure 149]. Open the drain valve and drain the coolant
into a container.

After all the coolant is removed, close the drain valve and
remove the hose.

Recycle or dispose of coolant in an environmentally safe
manner.

Mix the coolant in a separate container. (See Fluid
Capacities on Page 122.)

Add premixed coolant, 47% water and 53% propylene
glycol to the recovery tank. (See Checking Level on
Page 82.)

4,3 L of propylene glycol mixed with 3,8 L of water is the
correct mixture of coolant to provide a -37°C (-34°F)
freeze protection.

Remove the coolant fill cap. Fill the tank until it is at the
lower marker on the tank.

Use a refractometer to check the condition of propylene
glycol in your cooling system.

Run the engine until it is at operating temperature. Stop
the engine. Check the coolant level when cool. Add
coolant as needed.

Install the rear grill and close the rear door.

P-45490

P-45245