bobcat s205 User Manual
S205 Skid-Steer Loader
Operation & Maintenance Manual
Operation & Maintenance Manual
84
ELECTRICAL SYSTEM
Description
Figure 150
The loader has a 12 volt, negative ground alternator
charging system. The electrical system is protected by
fuses located in the cab on the steering control panel and
a 100 amp. master fuse [Figure 150] in the engine
compartment on the left side of the engine. The fuses will
protect the electrical system when there is an electrical
overload. The reason for the overload must be found
before starting the engine again.
charging system. The electrical system is protected by
fuses located in the cab on the steering control panel and
a 100 amp. master fuse [Figure 150] in the engine
compartment on the left side of the engine. The fuses will
protect the electrical system when there is an electrical
overload. The reason for the overload must be found
before starting the engine again.
Fuse And Relay Location / Identification
Figure 151
The electrical system is protected from overload by fuses
and relays under the fuse panel cover (1) [Figure 151]. A
decal is inside the cover to show location and amp
ratings.
and relays under the fuse panel cover (1) [Figure 151]. A
decal is inside the cover to show location and amp
ratings.
Remove the cover to check or replace the fuses.
Figure 152
The location and sizes are shown below and in
[Figure 152].
[Figure 152].
R - Relay
P-24651
P-13849
P-26323
1
REF
DESCRIPTION
AMP
REF
DESCRIPTION
AMP
1
Traction
30
11 Front & Marker
Lights
R
2
Fuel Shutoff
30
12 Fuel Shutoff
R
3
Power Plug
- -
13 Rear Lights
R
4
ACS/AWS/SJC
- -
14 Traction
R
5
Heater
25
15 Switch Power
R
6
Front & Marker
Lights
Lights
15
16 Starter
R
7
Rear Lights
15
17 Unswitched
Attach.
25
8
Bobcat Controller
25
18 Switched Attach.
25
9
Heater & Air
Conditioning
Conditioning
- -
19 Alternator &
Accessories
25
10
Glow Plugs
R
20 Accessory Plug
25
7117407
1
2
5
6
9
17
11
13
15
4
3
8
7
10
20
19
12
14
16
18
N-19660