Bunn CDS-3 User Manual

SERVICE (cont.)

FIG. 2 AUGER DRIVE COMPONENTS

Location

The auger drive components are located in the bottom

of the hopper assembly.

Removal, Cleaning and Replacement

1. Open the dispenser door.

2. Lift the hopper assembly over the retainer plates

(16) on hopper support plate (12) and slide hopper

assembly out the front of the dispenser.

3. Remove hopper lid (1) and empty product.

4. Pull off the ejector elbow (15) and remove the slide

gate (21).

5. Remove retainer ring (11) and washer (10) from

the bottom of the hopper base (9).

6. Remove wiper shaft (3), wiper blade (4) and wiper

drive gear (5) from the hopper base (9).

7. Remove auger wire (14) by pulling it out the front

of the hopper base (9).

8. Remove auger drive shaft (13) by removing the

retaining clip (6) from auger drive shaft.

9. Slide spacer (8) and auger drive shaft bracket (7)

off of the auger drive shaft (13).

10. Remove auger drive shaft (13) from hopper base

(9).

11. Wash components in a mild solution of dish de-

tergent using a bristle brush when needed.

AUGER DRIVE COMPONENTS

P1922

12. Rinse and dry each item thoroughly.

13. Check for damaged or broken components, replace

any if necessary and reassemble hopper assem-

bly.

14. Install hopper assembly in the dispenser by slid-

ing hopper assy on the hopper support plate (12)

until the hopper base (9) seats firmly behind the

retainer plates (16) on the hopper support plate

(12).

FIG. 3 AUGER DRIVE & HOPPER ASSEMBLY

1. Hopper Lid

2. Hopper

3. Wiper Shaft

4. Wiper Blade

5. Wiper Drive Gear

6. Retainer Clip

7. Auger Drive Bracket

8. Spacer

9. Hopper Base

10. Washer

11. Retainer Ring

12. Hopper Support Plate

13. Auger Drive Shaft

14. Auger Wire

15. Ejector Elbow

16. Hopper Retainer Plates

17. Auger Motor Bracket

18. Auger Motor

19. Dust Seal

20. Auger Motor Mounting

panel

21. Slide gate

P1894

29793 061599