SOEKS IMPULSE Magnetic field-analysis apparatus, Magnetic field tester 9 Data Sheet
Product codes
9
-40-
Instrument operation
1. It is recommended to read this manual carefully.
2. Install batteries (page 30, 36)
3. Switch on the instrument.
4. It is recommended to carry out individual instrument tuning before
measurements (page 35)
5. When turned on, the instrument automatically enters "EMF in LIVE
BUILDING" measurement mode. The first measuring result appears on the
screen approximately in 10 seconds, and then a new measuring cycle starts.
The measurement is carried out uninterruptedly until the instrument is
switched off regardless of its mode.
In order to obtain the most accurate results, the measurements
should be carried out in the following way:
● EMF in LIVE BUILDING
Turn off all home appliances, including local lighting, i. e. table
lamps, sconce, etc. Turn off the general illumination.
Put the instrument into the monitored area with upper side
pointing toward the wall, holding it with your fingers at arm's length. The
measurements shall be taken at a distance of 20 cm from the walls ad
windows and at a height of 0.5–1.5 m from the floor level.
Electric field (E) reading is displayed in the left side of the
indicator display. If the "HIGH LEVEL OF ELECTRIC FIELD" message
appears on the red background, it means that electric field level is increased
and reasons for it should be searched for.
Turn on the general illumination then, and take measurements in
the same points, however, only excess of magnetic field (B), which is
displayed in the right side of the screen, should be analyzed. If the " HIGH
LEVEL OF MAGNETIC FIELD" message appears on the red background, it
means that magnetic field level is increased and reasons for it should be
searched for.
While taking measurements, one should take into account that
data is updated approximately every 10 seconds, therefore the result should
be read out not earlier then 10 seconds after placement of indicator in the
monitored area.