Behringer Digital Mixer X32 Manual
music-group.com
behringer.com
1
X32 MIDI Implementation (06 May 2014)
MIDI RX > SCENES
Whenever program change messages in the range 1-100 are received on MIDI CH01, the corresponding
scene of the X32 internal show memory will be loaded.
scene of the X32 internal show memory will be loaded.
This requires the following preconditions:
•
Setup / remote
–
MIDI In/Out check marks must be set according to the connection on which MIDI input will be
accepted (via physical MIDI connectors on X32 or S16, or via XUF Card)
accepted (via physical MIDI connectors on X32 or S16, or via XUF Card)
–
MIDI In/Out check mark must be set for “Enable MIDI Scene Recall”
•
Setup / global
–
when tick mark “Confi rm Pop-Ups” / “Scene Load” is active, also MIDI scene recalls will only
become active after manual confi rmation
become active after manual confi rmation
–
if you prefer activating scenes via MIDI program changes immediately, un-check the
“Confi rm Pop-Ups” / “Scene Load” tick mark
“Confi rm Pop-Ups” / “Scene Load” tick mark
•
Scenes View / home
–
valid scenes must be stored in the internal X32 show fi le. It is not possible to recall
empty scenes.
empty scenes.
–
the scope of changes applied by a MIDI scene recall depends on the Scene Safes,
Parameter Safes and Channel Safes settings, same as with recalling the scene locally.
Parameter Safes and Channel Safes settings, same as with recalling the scene locally.
MIDI TX > SCENES
•
Every scene can be assigned one specifi c MIDI command/event. Each time the scene is loaded
the MIDI command will be sent out once. Possible choices for MIDI commands/events to be found
on Scenes View/MIDI page:
the MIDI command will be sent out once. Possible choices for MIDI commands/events to be found
on Scenes View/MIDI page:
–
Off > no message will be sent upon scene load
–
Program Change > select the MIDI Channel and the Program Number (using knobs 4/5 at the
main display)
main display)
–
Control Change > select the MIDI Channel, Controller number and value (using knobs 4-6 at
the main display)
the main display)
–
Note > select the MIDI Channel, Note number and velocity (using knobs 4-6 at the
main display)
main display)
•
will send out a Note On command directly followed by the same Note Off command