Whirlpool T-K1S User Manual
19
Error Codes
All Takagi units are self diagnostic for errors. If
there is a problem with the installation or the unit, it
will give a signal, through a flashing light on the
circuit plate, to communicate the source of the
problem. If the unit has a TK-RE01 remote control
installed, this will give also give a numerical error
code. Consult the following chart for the meaning
of an error code:
there is a problem with the installation or the unit, it
will give a signal, through a flashing light on the
circuit plate, to communicate the source of the
problem. If the unit has a TK-RE01 remote control
installed, this will give also give a numerical error
code. Consult the following chart for the meaning
of an error code:
TK-RE01
Computer Board
TK-RE01 Check
Point
03 Wrong
Gas
70 Computer
Board
Blinking One Time
71
Solenoid Gas Valve
31 Output
Thermistor
Blinking Two Times
32 Input
Thermistor
11 Hi-limit,
Igniter
12
Flame Sensor, Hi-limit
55
Main Gas Valve
51
Proportional Gas Valve
Blinking Three Times
72 Abnormal
Burning
61 Fan
Blinking Four Times
21 Pressure
switch
74
Remote
Controller
For technical support contact Takagi toll free at (888) 882-5244, or check
our website at www.takagi-usa.com.