Whirlpool T-K1S User Manual

 

2

 

PLEASE READ THIS MANUAL CAREFULLY 
AND FOLLOW IT EXACTLY FOR YOUR 
SAFETY. 
 

1.  Follow all local codes, or in the absence of 

local codes, follow the most recent edition of 
the National Fuel Gas Code, ANSI 
Z223.1/NFPA 54 in USA or the CGA standard, 
CAN/CGA B149.1 or .2 Installation Codes for 
Gas Burning Appliances in Canada. 

 
2.  Properly ground the unit in accordance with all 

local codes, or in the absence of local codes, 
with the National Electrical Codes, ANSI/NFPA 
70 in the USA or CSA standard C22.1 Canada 
Electrical Code Part 1 in Canada. 

 
3. Carefully plan where to install your Flash 

Water Heater. Insure that your heater will have 
enough combustible air, proper ventilation, and 
locate your heater where water leakage will not 
do damage to surrounding areas. If there is a 
possibility of water damage, install a suitable 
drain pan under the unit, which will not restrict 
combustible airflow. 

 
4.  Check the rating plate for the correct gas type, 

gas pressure, water pressure, and electrical 
rating. Do not install this unit if these 
requirements can’t be met. 

  

 

5.  If a problem should occur, turn off all hot water 

taps and turn off the gas. Call a trained 
technician, the Gas Company, or the 
manufacturer. 

 

6. 

WARNING: 

Do not disconnect the electrical 

supply if the temperatures will be near 
freezing. The Freeze Prevention Device will 
only work if the unit has proper electrical 
power. The Freeze Prevention Device is rated 
for temperatures down to 5º F (-15º C) in a 
wind free environment. The wind chill factor will 
cause the Flash Water Heater to freeze and be 
damaged at temperatures above 5º F (-15º C). 
Refer to the sections on Winterizing and the 
Freeze Prevention Device for more 
information. 

7. 

: Before bathing or showering 

always check the water temperature. Do not 
leave children or the infirm unsupervised in the 
shower or bath. The water temperature is set 
at 120º F (50º C) from the factory to maximize 
the amount of hot water you can use. Water 
temperature over 125º F can cause severe 
burns instantly or death from scalds. 

8. 

: Do not use this appliance if any 

part has been underwater. Immediately call a 
certified and trained technician to inspect and 
service the unit if necessary. 

9. 

: Do not store or use gasoline or 

other flammable vapors or liquids in the vicinity 
of this or any other appliance. 

10. 

WARNING: 

Do not reverse the water and gas 

connections, this will damage your heater and 
can cause severe injury or death from scalds. 
Follow the diagram below when installing your 
Flash water heater.