Wegener Communications IPUMP 562 User Manual

16 

 800092-01 Rev. A 

www.wegener.com

The 

 IRD is most often controlled via the 

 

 

. 

This system is managed at the uplink site, sending a control stream with the usual audio 
and video data streams. The 

 

 addresses units, and commands them to 

perform various functions.

Among its functions is the ability to enable or limit aspects of local control. Also, 

 has 

the ability to mute the audio and video of an IRD if it is inadvertently tuned to a frequency it 
is not authorized to receive.

If an RF Switch option module is installed, 

 controls which of the four RF feeds is 

being processed. For more information on this, see the 

 Manual, or contact your 

service provider.

There are four levels of control via 

. These levels are:

 

No Local Control - Push-buttons disabled

 

Read Only - No changes permitted

 

Limited - Changes may be made to Carrier Presets (pre-loaded values) only

 

Full - Full Local Control 

The 

 allows several functions for basic operation and optimum performance.

 

Tune to a carrier 

 

Configure LNB options 

 

Monitor Signal Quality 

 

Set Subtitling 

 

Configure operating options: 

 

Set Decoder options 

 

Setup Audio 

 

Set LAN IP Networking options 

 

Set Terminal options 

 

Set Printer options

 

Set User Relay

 

Set Date and Time information 

 

Set Unit Label 

 

Switch Application (to different software version) 

 

Monitor status information:

 

View Signal Quality 

 

Query Networking History 

 

Display LAN IP Network information 

 

Find Software Version information 

 

Clear Statistics used for diagnosis 

 

Play out play lists of media files

The functions listed above are illustrated below with instructions, OSD screens and other 
relevant information.