Wegener Communications IPUMP 562 User Manual
www.wegener.com
800092-01 Rev. A
47
Unity 552 User’s Manual
A
PPENDIX
1 T
ERMINAL
D
IAGTERM
C
OMMANDS
The iPump 562 provides command-line interface, Diagterm. The diagterm can be accessed
either using a RS-232 serial port or logging through LAN IP interface using Linux. The
diagterm commands are used to control or monitor the IRD operations. This method may be
used in conjunction other ways to control or monitor, namely,
either using a RS-232 serial port or logging through LAN IP interface using Linux. The
diagterm commands are used to control or monitor the IRD operations. This method may be
used in conjunction other ways to control or monitor, namely,
Compel
and OSD.
Apx 1.1 Diagterm Group Commands
Some of the Diagterm terminal commands are grouped under common group name. The
commands belonging to a group perform related functions. Following is a list of groups and
their commands along with synopsis for each. A general syntax for the group command is:
commands belonging to a group perform related functions. Following is a list of groups and
their commands along with synopsis for each. A general syntax for the group command is:
Table Apx 1.1: Diagterm Group Commands
Group Name: rp
Command
Synopsis
ca
Report Conditional Access Information
rec
Report Recovery Status
rf
Report RF Parameters
Group Name: r
Command
Synopsis
c
Report Carrier Status
st
Report Preset Table
s
Report Settings Status
p
Report Configuration Information
ns
Report Network Services Status
http
Report HTTP Information
g
Report
Compel
Group Table
r
Report Relays Status