Autostart CT-5060 User Manual

 

Note: Pressing the 

 and 

 buttons at the same time will activate the 

 output. 

Remote-starting 

Press the 

 button for approx. 1 second. The parking lights will come 

, 

informing you that the unit has received your signal. The engine will start 
approx. 5 seconds later. The parking lights will remain 

 during the pre-programmed run 

time. 

If the vehicle doesn’t start at the first attempt, the system will shut down, wait a few 

seconds, and try to start the engine again. It will try to start the engine 3 times before 
giving up. 

This unit is designed for Manual Transmissions only.  In order to remote-start the 

vehicle, the Unit must first be set to Ready mode.  If the Unit is not set to Ready Mode, it 

cannot remote-start the vehicle.  Once the system has been set to Ready Mode, the 
vehicle can be remote started and stopped at will (as long as the Unit never exits Ready 

Mode). 

1. 

Ensure that all the Doors are closed and that the Gear Lever is in the Neutral 

position. 

2. 

With the Engine already running, apply the Parking Brake. 

3. 

Within 20 sec. press 

LOCK, UNLOCK 

or 

 on the Transmitter. 

4. 

Remove the key: the Engine will go on running. 

5. 

Exit the vehicle and close the Door. 

6. 

Press either: 

a. 

LOCK 

to lock the Doors, arm the Alarm and shut down the Engine; 

b. 

 to unlock the Doors and shut down the Engine; 

c. 

START/STOP 

to shut down the Engine without affecting the Doors or;

 

d. 

 to lock all Doors and engage idle mode. 

Remaining in Ready Mode 

Once the vehicle is in Ready Mode you can start and stop the vehicle at wish. However, 

if any one of the following events occurs, the vehicle will exit Ready Mode – thus 

eliminating the remote start option until Ready Mode is restored: 

CT-5060 User Guide 

P. 2