Autostart CT-5060 User Manual

Page of 10
 
P. 3 
User Guide
 CT-5060 
•  Door opened; 
•  Hood opened; 
•  Brakes pressed; 
•  Parking Brake disengaged; 
•  Key turned to the 
IGNITION ON (RUN)
 position. 
Should any of the above occur, Ready Mode will be cancelled. 
Note: The unit will notify the user that it has exited Ready Mode by giving three slow 
flashes of the vehicle’s Parking Lights. 
Vehicle Presets 
Heater & Heated Seat 
When leaving the vehicle it is recommended to preset the accessory controls in 
preparation for the next remote start. Settings for the blower motor (fan), front and rear, 
as well as heated seats (if equipped) should not be left on 
HIGH
. It is recommended to 
leave the settings on 
LOW
 or 
MEDIUM
 instead. 
Windshield Wipers & Radio & Headlights 
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to 
become energized while running under remote start. When leaving the vehicle you must 
ensure that the windshield wiper and headlight switches are 
OFF
. Leaving the headlight 
switch 
ON
 on certain vehicles could cause them to remain 
ON
 even after remote starter 
shut down, resulting in a dead battery. 
Driving Off 
With the vehicle running under remote control, press the 
UNLOCK
 button to 
DISARM
 and 
UNLOCK
 the doors. Enter the vehicle and do the following: 
•  Turn the ignition key to the 
IGNITION ON (RUN)
 position. (Do not turn the key to the 
START
 
position while the engine is running. This will cause the starter motor to re-engage.) 
•  Press the brakes to disengage the remote starter unit. 
You are now ready to drive off. 
Idle Mode 
This feature allows you to remove the key from the ignition and leave the vehicle running 
for its pre-programmed run time while you are away from your vehicle. This feature is 
handy if you need to stop for a quick delivery, or at a convenience store. 
 
To enable the Idle Mode: 
1.  Press and hold 
LOCK
UNLOCK
 or 
START/STOP
 on your transmitter while the engine is 
running. 
2.  The parking lights will come 
ON
3.  Remove the key, exit the vehicle; 
•  Press the 
LOCK
 button if you need to lock the doors while the engine is running. 
Caution: Do not leave children or pets unattended in a car running in Idle Mode.