Amana AGK01 Installation Instruction

Page of 20
5
TRANSPORTATION DAMAGE
All units are securely packed in shipping containers tested according to International Safe Transit Association specifications. The
carton must be checked upon arrival for external damage. If damage is found, a written request for inspection by the carrier’s agent
must be made immediately.
In the event of damage, the consignee must:
1.
Make notation on delivery receipt of any visible damage to shipment or container.
2.
Notify carrier promptly and request an inspection.
3.
In case of concealed damage, carrier should be notified as soon as possible—preferably within 5 days.
4.
File the claim with the following supporting documents within the 6 month statute of limitations.
a. Original Bill of Lading, certified copy, or indemnity bond.
b. Original paid freight bill or indemnity in lieu thereof.
c. Original invoice or certified copy thereof, showing trade and other discounts or reductions.
d. Copy of the inspection report issued by carrier’s representative at the time damage is reported to the carrier.
The carrier is responsible for making prompt inspection of damage and for a thorough investigation of each claim. The distributor or
manufacturer will not accept claims from dealers for transportation damage.
External Transformer Kit
Water or Steam Valve Kit
Condensate Disposal Pump Kit
Remote Temperature Sensor Kit
Wireless RF Antenna
Wireless RF Thermostat
Wireless Motion Sensor
Wireless Door Switch
Wired Motion Sensor
Wired Door Switch
Extra Deep Sleeves
UNIT ACCESSORIES
This unit is designed for through-the-wall installation in new or existing buildings.  To complete the installation of this PTAC, an
insulated wall sleeve and an outdoor grille (either the stamped aluminum grille or the architectural grille) are required.
The chassis and the cabinet front are shipped in one carton. Optional accessories to complete a particular installation are the
following:
Optional Accessories
STC
Charcoal Filter
Wall Sleeve Kit
Key Lock Kit
Drain Kit
Filter Kit
Heater Kit
Subbase Kit
Hard Wire Kit
Main Duct Kit
Power Vent Kit
Leveling Legs Kit
Hydronic Heat Kit
Stamped Grille Kit
Deflector Grille Kit
Polymer Grille Kit
Extension Duct Kit
Wall Thermostat Kit
Fuse Holder Kit
Power Switch Kit
Wire Harness Kit
Circuit Breaker Kit
Architectural Grille Kit
Remote Escutcheon Kit
NOTE:  Consult sales literature for the appropriate voltage and amperage selections, if applicable. For additional details and
illustrations of the accessories, refer to the Architect’s and Engineer’s Manual.
General Information