Amana AGK01 Installation Instruction

6

To ensure that the unit operates safely and efficiently, it must be installed, operated and maintained according to these installation

and operating instructions and all local codes and ordinances or, in their absence, with the latest edition of the National Electric

Code. The proper installation of this unit is described in the following sections. Following the steps in the order presented should

ensure proper installation.

• 

• 

Before the chassis can be installed in the wall sleeve, the sleeve

stiffener and the rear closure panel must be removed.

1.

Remove the zigzag folded cardboard sleeve stiffener.

2.

Remove the rear closure panel by folding the four flaps.

3.

Grasping the top and bottom flanges of the rear closure panel
pull the entire panel out diagonally from one side.

During normal reverse cycle heating operation, condensate water

will drain out of the rear of the wall sleeve. If this water is

objectionable, a drain kit should be installed. The drain kit has

provisions for draining the water from either the right or left side

of the sleeve externally or from the bottom of the sleeve inter-

nally. The drain kit must be installed before the outdoor grille is

installed. Refer to the Installation Instructions supplied with the

drain kit for a complete description of the installation procedure.