Lynx L36ASRLP Owner's Manual

34

the grill is factory set to use 

either propane (lp) or natural 

gas (

either pr

either pr

nat). 

opane (

opane (

it is critical that the 

opane (

opane (

gas you use matches that 

which the grill was set up for.  

gas you use matches that 

gas you use matches that 

you can verify that by 

which the grill was set up for.  

which the grill was set up for.  

yy

checking the 

rating plate

. 

the rating plate is located in 

one or more of the following 

he rating plate is located in 

he rating plate is located in 

places: 

attached to the underside 

of the drip tray 
on the heat shield behind 

the front panel 
on the inside left cabinet 

wall 

one is underneath the drip tray.

model numbers and gas type. 

model numbers and gas type. 

ensure that the gas supplied 

meets with the minimum 

nsure that the gas supplied 

nsure that the gas supplied 

pressure requirements. Do not 

operate the grill on any gas 

pr

pressure requirements. Do not 

essure requirements. Do not 

other than that for which the 

operate the grill on any gas 

operate the grill on any gas 

grill has been set.

fuel

wc

max 

inlet

wc min 

under 

full load

nat gas

7 in

4 in

as

7 in

4 in

as

7 in

4 in

lp

14 in

11 in

14 in

11 in

Water Column Requirements 

Both the regulator and the 

manifold orifices have been 

Both the regulator and the 

Both the regulator and the 

tuned for the type of gas 

specified on the rating plate. 

tuned for the type of gas 

tuned for the type of gas 

converting to a different type 

of gas requires a conversion 

onverting to a different type 

onverting to a different type 

kit, available from 

of gas requires a conversion 

of gas requires a conversion 

lynx or 

ll

from your dealer and must be 

installed by a qualified techni

om your dealer and must be 

om your dealer and must be 

-

cian. 
all installation and all instal-

lation parts must conform to 

local codes with the 

lation parts must conform to 

lation parts must conform to 

national 

lation parts must conform to 

lation parts must conform to 

electrical code, ansi Z223.1/

nfpa

nfp

nfp  70 latest edition and 

the national fuel gas code, 

ansi Z223.1/nfpa 54 in the 

u.s and cga-B149.1/.2 in 

canada.
canadian installations must 

conform to cga-B149.1/.2 

natural gas/propane installa-

tion code. (

natural gas/propane installa-

natural gas/propane installa-

c

natural gas/propane installa-

natural gas/propane installa-

anada) 

natural gas/propane installa-

natural gas/propane installa-

lynx r

ll

ecommends that 

only qualified profession

ynx r

ynx r

-

als perform the required 

only qualified profession

only qualified profession

plumbing on this product.

als perform the required 

als perform the required 

to ensur

tt

e satisfactory per-

formance, the gas supply 

e satisfactory per-

e satisfactory per-

line must be sized to ac-

formance, the gas supply 

formance, the gas supply 

commodate the total Btu

requirements of all the gas-

fired equipment that will be 

requirements of all the gas-

requirements of all the gas-

connected to that line. 

fired equipment that will be 

fired equipment that will be 

in no case should pipe less 

than 3/4” inside diameter or 

n no case should pipe less 

n no case should pipe less 

1” outside diameter ever be 

used to connect this product.

calculate the total Btu

output of all equipment 

and refer to “

output of all equipment 

output of all equipment 

indeX: g

output of all equipment 

output of all equipment 

as 

supply line Runs” for 

allowable run distances 

upply 

upply 

for ¾ inch pipe.  failure 

to meet these minimum 

for ¾ inch pipe.  

for ¾ inch pipe.  

requirements may reduce 

performance of the grill 

requirements may reduce 

requirements may reduce 

and any other appliances 

performance of the grill 

performance of the grill 

running on that supply line. 

and any other appliances 

and any other appliances 

always keep supply line 

runs as short as possible. 

lways keep supply line 

lways keep supply line 

(see indeX: “Btu output” for 

specific model ouputs)

a gas shut-off valve must 

be installed in an easily 

accessible location by a 

qualified plumber. 

accessible location by a 

accessible location by a 

Never coNNect a gas liNe directly to the grill. a pressure regulator must be 

iNstalled oN all gas equipmeNt. all local codes require it aNd ly

ll Nx supplies the 

correct regulator with your grill. removiNg or failiNg to iNstall the pressure 

regulator caN result iN fire aNd serious persoNal iNjury aNd will void the 

warraNty.