Marvel 15" Built-In Ice Maker - Black Cabinet & Overlay Door User Manual

NOTE

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS

Model

30iMT

145/8”

(37.1cm)

305/16”

(77.0cm)

30iMAT

145/8”

(37.1cm)

2711/16”

(70.3cm)

For overlay with lock option panel

thickness to be 3/4” (19mm) maxi-

mum to 5/8” (16mm) minimum.

Weight of the overlay panel

should not exceed 20 pounds (9.1

kilograms).

For the door to work properly

it is necessary to maintain a

minimum space of 9/32” (7mm) between the door and cabinet

flange as shown . This space can be adjusted by adjusting the

top and bottom hinge adapters.

Figure 11

Table A

Front of

overlay

panel

Step 5: Drill hinge clearance holes in overlay panel

Set the overlay panel on the door front, align the edges, and

clamp together. Clamp the panel firmly but be careful not to

damage the door or the panel. Mark center of hinge adapter

hole on wood panel, top and bottom. (See Figure 12.) Remove

wood panel from door and drill 5/16” (8mm) diameter clearance

holes into the overlay panels 3/4” (20mm) deep. These will be

clearance holes for the top and bottom hinge pins.

This is also a convenient time to locate and drill the holes for

your handle. Most often the handle is to match that of the sur-

rounding cabinetry. If your handle attaches from the back-side

of the custom panel, locate the mounting holes while the panel

Step 1: Verify door alignment

Verify that the door is aligned correctly with the cabinet

prior to fabricating the custom panel. Failure to do so may

result in mis-alignment of the custom panel with the hinge

bracket. The door should be parallel to the sides and top of

the ice machine. If alignment is necessary the door may be

adjusted by loosening the 2 screws which secure the top and/

or bottom hinge adapter brackets, located on the top and

bottom of the door and adjusting the door side to side. Use a

5/32” allen wrench, for this procedure. (See Figure 10 below).

When finished aligning the door, tighten the screws securely.

Remove top hinge

pin to remove the

door.

Door should be

parallel to top

and sides of ice

machine.

Step 2: Remove door

Remove the top hinge pin from the hinge with an 1/8” allen

wrench. Remove the door by angling the top of the door out-

ward and lifting the door off the bottom hinge.

(See detail in Figure 10).

Step 3: Remove gasket

Lay the door on its front being careful not to scratch it. To gain

access to the screw mounting holes remove the door gasket by

peeling up and out of the channel.

Step 4: Cut overlay panel

Depending on the ice machine model cut the overlay panel to

the dimensions shown in Figure 11 and Table A.

Figure 10

Hinge adapter bracket lo-

cated on the top and bottom

of the door.

9/32”

(7mm)