Hearth & Home Technologies be-36-c User Manual
Hearth & Home Technologies • BE-36-C, BE-36-CIPI • 397-981 Rev. V 1/07
24
A. Choosing the Top or Rear Vent
Appliance Preparation
7
Figure 7.2 Cut the seal cap strap across the rectangles
next to the disk. The top heat shield may need to be
removed to perform this step.
removed to perform this step.
Figure 7.3 Remove the white gasket material covering
the seal cap.
the seal cap.
Figure 7.4 Remove the seal cap.
Figure 7.5 Remove the insulation basket and white insula-
tion from the center vent pipe.
tion from the center vent pipe.
Figure 7.1 For top vent, remove the two screws holding
the elbow heat shield in place. Use this heat shield over
the fi rst elbow if applicable. For rear vent skip this step.
the elbow heat shield in place. Use this heat shield over
the fi rst elbow if applicable. For rear vent skip this step.
Figure 7.6 Remove the insulation from the outer vent
pipe. For rear venting there is no insulation in the outer
vent pipe. Replace the top heat shield.
pipe. For rear venting there is no insulation in the outer
vent pipe. Replace the top heat shield.
CAUTION
Sharp Edges
• Wear protective gloves and safety
• Wear protective gloves and safety
glasses during installation.
Note: Actual unit may look different than the fi replace shown
in this section.
in this section.