Hearth & Home Technologies be-36-c User Manual

Hearth & Home Technologies   •  BE-36-C, BE-36-CIPI  •  397-981 Rev. V  1/07

38

This appliance requires a 110 VAC supply to the appliance 
junction box for operation. A wiring diagram is shown in 
Figure 10.3.
This appliance is equipped with an Intellifi re control valve 
which operates on a 3 volt system. 
This appliance is supplied with a battery pack and a 3 volt AC 
transformer, which requires the installation of the supplied 
junction box. It is highly recommended that the junction box 
be installed at this time to avoid reconstruction.
The battery pack requires two D cell batteries (not 
included). 

Battery polarity must be correct or module damage will occur.

Label all wires prior to disconnection when servicing controls. 
Wiring errors can cause improper and dangerous operation. 
Verify proper operation after servicing.

Shock hazard.
•  Replace damaged wire with type 105º C 

rated wire.

•  Wire must have high temperature insulation.

Batteries cannot be placed in the battery pack while 
using the 3 volt AC transformer. The transformer must 
be unplugged if the battery pack is used or battery life 
will be reduced.

•  This standing pilot ignition system wiring does not require 

a 110 VAC supply to operate. 

•  It is recommended that a 110 VAC junction box be in-

stalled for use with a fan or remote control. (See Figure 
10.4 for junction box wiring).