Hearth & Home Technologies be-36-c User Manual

39

Hearth & Home Technologies   •  BE-36-C, BE-36-CIPI  •  397-981 Rev. V  1/07

If the box is being wired to a wall mounted 
switch for use with a fan (See Figure 10.5):

•  The power supply for the appliance must 

be brought into a switch box.

•  The power can then be supplied from 

the switch box to the appliance using a 
minimum of 14-3 with ground wire.

•  At the switch box connect the black (hot) 

wire and red (switch leg) wire to the wall 
switch as shown.

•  At the appliance connect the black (hot), 

white (neutral) and green (ground) wires 
to the junction box as shown.

•  Add a 1/4 inch insulated female connector 

to the red (switch leg) wire, route it through 
the knockout in the face of the junction 
box, and connect to the top fan switch 
connector (1/4 inch male) as shown.

If the box is being wired from the appliance:
•  Remove the screw attaching the junction 

box to the outer shell, rotate the junction box 
inward to disengage it from the outer shell 
(see Figure 10.4).

•  Pull the electrical wires from outside the 

appliance through this opening into the valve 
compartment.

•  Loosen the two screws on the Romex 

connector (not included with unit), feed the 
necessary length of wire through the connector 
and tighten the screws.

•  Make all necessary wire connections to the 

receptacle and assemble the receptacle and 
cover to the junction box.

WHT

WHT

BLK

BLK

NOTE: Do NOT wire 
110VAC to wall switch.