Hearth & Home Technologies be-36-c User Manual

37

Hearth & Home Technologies   •  BE-36-C, BE-36-CIPI  •  397-981 Rev. V  1/07

NOTE: This appliance must be electrically wired and grounded 
in accordance with local codes or, in the absence of local 
codes, with National Electric Code ANSI/NFPA 70-latest 
edition or the Canadian Electric Code, CSA C221.1.

•  This appliance may be used with a wall switch, wall 

mounted thermostat and/or a remote control.

•  If using thermostat use one compatible with a millivolt 

gas valve system.

•  Follow parameters for locating thermostat (see individual 

thermostat instructions) to ensure proper operation of 
appliance.

•  Use low resistance thermostat wire for wiring from igni-

tion system to the wall switch and thermostat.

•  Keep wire lengths short as possible by removing any 

excess wire length.

•  Low voltage and 110 VAC voltage cannot be shared 

within the same wall box.

Wire 110V to electrical junction box.
Do NOT wire 110V to valve.
Do NOT wire 110V to wall switch.
•  Incorrect wiring will damage millivolt valves.
•  Incorrect wiring will override IPI safety lockout 

and may cause explosion.

This appliance requires 110-120 VAC be wired to the 
junction box either for use of optional accessories (stand-
ing pilot ignition) or for proper operation of the appliance 
(Intellifi re ignition). Refer to Figure 10.1 to determine if the 
appliance uses an Intellifi re ignition system or Standing 
Pilot ignition system.

Open the control access panel to view wiring system and 
gas valve. If this appliance has a red or black ignitor button 
(as noted in Figure 10.1) this appliance has a Standing Pilot 
ignition system. If there is no red or black ignitor button, 
this appliance has an Intellifi re ignition system.