Lucent Technologies 555-661-140 User Manual
MERLIN LEGEND Communications System Release 6.1
Installation
Installation
555-661-140
Issue 1
August 1998
Installing the Control Unit
Page 2-19
Installing the Basic Carrier
To install the basic carrier, follow the steps below:
!
Mark the screw-hole locations on the backboard, using the basic
carrier or the template supplied with the plastic preassembled
backboard as a guide. See Figure 2–5.
Make sure the carrier is level before marking the holes.
carrier or the template supplied with the plastic preassembled
backboard as a guide. See Figure 2–5.
Make sure the carrier is level before marking the holes.
!
Drill a pilot hole in the center of each of the four screw-hole marks.
!
Anchor the screws approximately halfway into the backboard.
!
Position the carrier on the screws and slide the carrier to the left.
!
Tighten the screws.
Figure 2-5.
Marking the Basic Carrier Screw Holes
Backboard
Basic
Carrier
Carrier
Mounting
Screw
Screw
Mounting Surface