Guardian Technologies 004582-2 Manual De Usuario

Set the palleted carton on a rigid flat surface.
Remove staples along bottom of carton that fasten carton to pallet. 

Open carton from top.

Remove all packaging material.
Remove separate accessory box.
Lift carton off the generator.
 Remove generator from shipping pallet by removing bolts through 

the shipping brackets (Figure 1).

Check all contents. If any parts are missing or damaged locate an 
authorized dealer at 1-800-333-1322.

Contents include: 

Wheel Axle 

•  Bolt-on tubular handle

2 – Washers 

•  2 – Pneumatic Wheels

2 – Wheel Spacers 

•  2 – Axle Bracket Assemblies

2 – Cotter Pins 

•  Bolt-on Foot

2 – Spark Plugs 

•  Spark Plug Wrench

Air Filter 

•  Oil Filter

Pre-cleaner • 

Battery 

Charge 

Cable

6 – Carriage Bolts, Washers, Nuts

•
•

•
•
•
•

•
•
•
•
•
•
•
•

The generator requires some assembly prior to using it. If problems 
arise when assembling the generator, please call the Generator 
Helpline at 1-800-333-1322.

The wheel kit is designed to greatly improve the portability of the 
generator. A socket wrench with a 9/16” socket, a 1/2” socket, a 
1/2” wrench and a pair of pliers are the tools that will be needed for 
assembly of the wheel kit.

Refer to Figure 2 and install the wheel kit as follows:
Place the generator on a hard flat surface.
Stand at the engine end of the unit and gently tilt the generator 

forward, high enough to place wooden blocks beneath the cradle. 
This will allow space to install the wheel assemblies.

Attach an axle bracket assembly with attached sleeve to either side 

of the frame. Ensure the sleeve faces outward.

Slide the axle through the sleeves on the axle brackets.
Slide one wheel with flat washer to the outside and a spacer to the 

inside onto each end of the axle. Make sure the air inflation valve 
on the wheel is facing outward.

Insert retaining pins and using pliers, bend out the ends to prevent 

the pins from falling out of the axle. Remove the wooden blocks.

Attach the handle by aligning one side of the handle on the cradle, 

then spread the handle around the cradle and let it spring into 
place. Secure the handle to the frame using the 5/16’ hex head 
bolts provided. Check each fastener to ensure that it is secure. 

Using the handle, lift the unit high enough to place wooden blocks 

under the unit. Attach the front support foot to the underside of the 
cradle using the 3/8” carriage bolts provided.

Remove the shipping brackets from the cradle, if it has not already 

been done.

•
•
•

•

•
•

•

•

•

•

4