Cognitive Solutions A799 Manual De Usuario

Chapter 2: Diagnostics and Configuration

Revision D 12/09

A799-PG00001D

Printer configuration

Printers are shipped with all the functions and parameters preset at the factory. Settings for various printer parameters
can be changed. This menu is printed on the receipt and scrolls through instructions for selecting and changing any of the
functions or parameters.
Note:

When changing the paper type you will either need to send the “Set paper type” (1D 81 mn) command or make

a selection in the configuration menu.

Caution: Be extremely careful changing any of the printer settings to avoid inadvertently changing other settings that

might affect the performance of the printer.

The following functions and parameters can be changed in the scrolling configuration menu (except as noted):

• Communication Interfaces

  RS-232C serial interface (25-pin)
  Universal serial bus (USB)/RS232 Serial (9-pin)
  Ethernet
  Powered USB

• RS-232C serial interface settings

  Baud rate
  Data bits (can not be changed)
  Stop bits (can not be changed)
  Parity (can not be changed)
  Hardware (DTR/DSR) or software (XON/XOFF)

flow control

Data reception errors
Alternate DTR/DSR

• Diagnostic Modes

  Normal
  Datascope
  Receipt test

• Printer Emulations

  Native mode
  A794 emulation
  A793 emulation
  LEGACY emulation

• Printer settings and functions

  Emulation/Software options submenu
    Printer ID mode
    Default lines per inch
    Carriage return usage
    Default font
    Font size
  Hardware options submenu
    Color density
    Monochrome print density
    Power supply wattage (max power)
    Knife option
    Partial cut distance
    Paper low sensor
    Paper width
    Printhead setting

For more information about See this section

Using the configuration menu “Configuring the printer”
to configure the printer

on page 16.