Simrad AP26 Manual De Usuario
Installation
20221586B
17
2.2
ON/OFF - Standby mode
Note !
At first time turn on see paragraph 4.1.
A single press on the STBY button switches the system ON and
the following status displays are shown:
A single press on the STBY button switches the system ON and
the following status displays are shown:
Autopilot computer model
P00 M00 S000
AC20
Simrad
Self check
Power board revision
Main board revision
Autopilot model
HW rev. 00
SW 1.0.00
AP26
Simrad
Hardware revision
SW 1.0.00
Software version
Software release
Software release
Software version
Sn xxxxxx
SimNet no.
SW and HW revisions shown are examples only.
After approximately 5 seconds, the system is operative and the
unit that was turned on will show the Standby mode display.
Other units in a multistation system will display "Inactive".
Control is transferred to any single unit by pressing its’ STBY
button.
After approximately 5 seconds, the system is operative and the
unit that was turned on will show the Standby mode display.
Other units in a multistation system will display "Inactive".
Control is transferred to any single unit by pressing its’ STBY
button.
The main Standby mode display
shows the current heading.
Alternatively, the Standby mode
display can show the following
information by a long press on
the TURN/DODGE/INFO
button:
shows the current heading.
Alternatively, the Standby mode
display can show the following
information by a long press on
the TURN/DODGE/INFO
button:
− Standby mode
− Current heading 345°M
− Compass source: Rate
− Current heading 345°M
− Compass source: Rate
compass
− Rudder angle =00°.