Simrad AP26 Manual De Usuario

Simrad AP26 and AP27 Autopilots 

18

 

20221586B

 

A long press (2-3 sec.) on the STBY button switches the system 
OFF and during this time, the alarm will sound. 

Note ! 

In an emergency, it is possible, on a multistation system, to turn 
OFF the system at any control unit by pressing the STBY button 
for 2-3 seconds. 
STBY mode is the mode that is used when steering the boat at 
the helm. 

 

When the course knob and the PORT/STBD buttons are used 
for settings etc., an icon will flash on the screen to tell that no 
course changes can be made unless you press the AUTO 
button. 

In the event there is an audible alarm with explaining text on the 
control unit, refer to section 6 Trouble shooting. 

Note ! 

The information in section 2.3 only applies if your autopilot is 
driving a Simrad MSD50 Stern Drive. 
The MSD50 Stern drive unit has a relative feedback signal which 
needs a zero point setting after the autopilot has been turned on. 
Refer to the MSD50 manual for further information. 

Note ! 

If you do not need a rudder angle display when leaving the dock, 
just steer the boat manually on a straight course and press the 
AUTO button. The zero point is then set automatically. 
If you prefer to use the rudder angle display when leaving the 
dock, proceed as follows: 

After turn on the rudder angle 
display will alternate between 
10 degrees port and starboard 
to indicate that the "rudder" 
zero point need be set.