Electrolux E30GC70FSS Guía Del Usuario

Porcelain Enamel
Burner Grates, Burner Caps

Surface Burners
Burner Head

For general cleaning, use hot, soapy water and a cloth. For more difficult soils and
built-up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30
to 60 minutes. Rinse with a damp cloth and dry. DO NOT use abrasive cleaners on
any of these materials; they can scratch.

Clean burner grates in the dishwasher and dry upon removal.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a
1:1 solution of clean water and ammonia. 

If necessary, cover difficult spots with an

ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a
damp cloth, then scrub with a soap-filled scouring pad. Rinse and wipe dry with a
clean cloth. Remove all cleaners or the porcelain may become damaged during
future heating. DO NOT use spray oven cleaners on the cooktop.

The holes in the burners of your cooktop must be kept clean at all times for proper
ignition and a complete, even flame. Clean the burner holes routinely with a small
gauge wire or needle and especially after bad spillovers which could clog these
holes.

To remove, clean and replace sealed burner units; follow the instructions in General
Care & Cleaning section under Cleaning the Burner Grates, Burner Caps,
Burner Heads. For stubborn stains, scrub with soap and water or a mild abrasive
cleanser and damp cloth. Dry the burners  thoroughly in a warm oven for 30 minutes.
Then replace them, making sure they are seated and level. DO NOT put burner units
in the dishwasher.

Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean
water and a cloth. Do not use cleaners with high concentrations of
chlorides or chlorines. Do not use harsh scrubbing cleaners. Only use
kitchen cleaners that are especially made for cleaning stainless steel. Always
be sure to rinse the cleaners from the surface as bluish stains may occur
during heating that cannot be removed.