GE zem200bf Instruccion De Instalación

12

• Flat-blade screwdriver

• Phillips screwdriver

• Drill and 1/4" bit

• Nail or center punch

• Pencil and ruler

• Scissors

• Hammer

• Tape

• Safety glasses

• Two brackets (supplied)

Template 1

Template 2

• Carefully remove the four plastic plug buttons

from oven top and the two screws at top rear
flange of case.

• Remove the two top case screws on the back

of oven. Retain screws.

• Select correct template and rear brackets for

this model. (See Template/Rear Bracket
Reference Sheet.)

• Secure the two rear brackets to back of the

oven, left and right, using screws removed
earlier.
– Make sure brackets are level and flush with

top surface of case.

• Cut Template 1 along dotted lines.

• Place template 2 inside the cabinet:

– If cabinet is less than 12" deep, cut off front

edge of template to fit, using template cut
lines as a guide.

– If cabinet has a recessed shelf, measure the

thickness of the front rail and cut that
amount off the front edge of template.
This will allow template 2 to lie flat.

• If you have a partition, you must:

– Cut Template 2 into 2 pieces to fit each

side of the partition.

– Position one piece of Template 2 inside the

cabinet with front edge even to cabinet
front edge.

– Position template 1 on front of the cabinet

so that the arrow is aligned with the hole
center line on template 2.

Installation

Case

Emboss

Right Side

Left Side

15 

13/32"

Mounting holes for the oven should be drilled
from the inside, if cabinet shelves are remov-
able to allow enough space. Holes may be
drilled from bottom, if necessary.

Buttons