GE zem200bf Instruccion De Instalación
13
To drill
from inside
(continued)
from inside
(continued)
To drill from
bottom
bottom
If cabinet
has a
partition
has a
partition
– Position remaining piece of Template 2 inside
cabinet and align hole center line with arrows
on Template 1.
on Template 1.
– Cut excess paper from center of Template 2 so
it will lie flat.
– Distance from right hole center to left hole
center should measure distance indicated on
template.
template.
– Tape remaining portion of Template 2 in
place.
• With template secured in place, check again
that hole center lines on Template 2 are
straight, and that distance from right to left
hole center measures distance shown on
template.
straight, and that distance from right to left
hole center measures distance shown on
template.
• Position Template 2 flat against underside of
cabinet:
– If cabinet is less than 12" deep, cut that
– If cabinet is less than 12" deep, cut that
amount off front edge of template.
– If cabinet has a front rail, cut front edge of
template to fit; place cut edge against back
of front rail.
of front rail.
– Cut template to fit around corner brackets
or glue blocks underneath cabinet.
If cabinet has partition:
– Cut Template 2 into two pieces to fit on
either side of partition.
– Align front edge of one template piece with
front edge of cabinet or back of front rail;
tape in place.
tape in place.
– Tape Template 1 to rear of cabinet,
aligning arrow with hole center line on
Template 2.
Template 2.
– Position remaining piece of Template 2
under cabinet and align hole center line
with arrows on Template 1.
with arrows on Template 1.
– Cut excess paper from center of Template 2
so it will lie flat.
– Distance from right hole center to left hole
center should measure distance indicated
on template.
on template.
– Tape remaining portion of Template 2 in
place.
Installation
Microwave Oven