Citel 6000 Guía Del Usuario
PBXgateway
™
& EXTender
TM
6000 System Administrator’s Guide
104
5. Enter a password so the user can access their email. (optional) Ask your System
Administrator if you are unsure if this is required for your SMTP services.
Figure 62: SMTP Server Configuration
Console Setup Wizard (Gateway and EXTender)
A console setup wizard has been created for the PBXgateway and EXTender 6000, and a phone
interface setup wizard has been created for the EXTender 4000. The setup wizard will guide a
user through most of the required programming and configuration required to complete the initial
setup of the units, via the VT100 management console accessed through the DB9 serial port on
the PBXgateway. Parameters not configurable through the wizard can be set through the
Management Interface.
When a unit is first powered up it will check a Setup Wizard flag. If the flag is set then the
standard console UI will be displayed. If the flag is not set then the user will be asked whether
they would like to run the Setup Wizard. After this initial prompt the Setup Wizard flag will be set,
preventing the user from being asked to run the Wizard again. The Setup Wizard can also be
accessed through the console Management Interface in case the user wants to run it later.
Portion of the variables configured through Setup Wizard:
• Unit Name
• Region Code
• PBX Type (Note: This is the only location to set this parameter)
• Network Connections
• Enable All Ports
• Voice Compression
• IP Configuration
interface setup wizard has been created for the EXTender 4000. The setup wizard will guide a
user through most of the required programming and configuration required to complete the initial
setup of the units, via the VT100 management console accessed through the DB9 serial port on
the PBXgateway. Parameters not configurable through the wizard can be set through the
Management Interface.
When a unit is first powered up it will check a Setup Wizard flag. If the flag is set then the
standard console UI will be displayed. If the flag is not set then the user will be asked whether
they would like to run the Setup Wizard. After this initial prompt the Setup Wizard flag will be set,
preventing the user from being asked to run the Wizard again. The Setup Wizard can also be
accessed through the console Management Interface in case the user wants to run it later.
Portion of the variables configured through Setup Wizard:
• Unit Name
• Region Code
• PBX Type (Note: This is the only location to set this parameter)
• Network Connections
• Enable All Ports
• Voice Compression
• IP Configuration