Citel 4100 Guía De Instalación

 

This section is a quick reference list of the essential configuration steps that must 
be performed during the execution of the Setup Wizard and/or after the Setup 
Wizard has been run to ensure proper functionality of the units. For a full 
description of the features described below refer to the System Administrator’s 
Guide. 

1.  Enable or disable individual ports (disable ports that are not in use). 

Path: Remote->Configuration->Port->Port_1 (and Port_2) 

2.  Set the user IDs for each port to “map” remote users with specific PBX ports. 

Path: Remote->Configuration->Port->Port_1 (and Por_2) ->User ID 

3.  Set the IP Destination address that the Remote will use to connect to the 

PBXgateway. This is simply the address of the PBXgateway. 

Path: Remote->Configuration->Connect 

4.  Set the IP parameters to allow the Remote to communicate over the IP 

network. 

Path: Remote->Configuration->IP->LAN->Address 

5.  Allow Tenet and FTP access for administrative and upgrade purposes. 

Path: Remote->Configuration->IP->LAN 

FTP should always be disabled when not performing an upgrade or file transfer 
to and from the unit. 

6.  Enable the Analog Port on the Remote (if equipped), enable or disable the 

ringing, assign a Dial Key, assign a Dial Prefix and/or and Emergency 
Number. See the System Administrator’s Guide for full details. 

Path: Remote->Configuration->Port->Port_1 (and Port_2) ->More 

 

© Copyright 2007 Citel plc All Rights Reserved