Craftsman 47099 Manual De Usuario
10
1
3
6
INSTALL CARTRIDGE
OPERATING INSTRUCTIONS
!
Notice
Do not damage seals of
equipment being lubricated by excessive
pressure or lubricant volume.
pressure or lubricant volume.
!
Notice
If grease does not come out of
coupler (1) after ten strokes of lever
handle (3), refer to Expel.Air.Pockets
section on page.5.
handle (3), refer to Expel.Air.Pockets
section on page.5.
Do not over pressurize grease gun.
Extreme pressure may cause nozzle
extension to burst.
extension to burst.
Use only identical part nozzle exten-
sion replacement. See Service.Parts list
on page.6.
on page.6.
Keep hands clear of the extension
during operation of the grease gun.
Grease gun can develop high pressure
up to 10,000 psi (689 bar). Use safety
glasses and gloves for protection during
operation.
Grease gun can develop high pressure
up to 10,000 psi (689 bar). Use safety
glasses and gloves for protection during
operation.
Failure to comply with this warning
may result in death or serious injury.
WA R N I N G
1. While holding grease gun container
tube (6), loosen grease gun head (10)
two turns.
two turns.
1. Wipe fittings clean before lubricating.
2. Push coupler (1) onto fitting at slight
2. Push coupler (1) onto fitting at slight
angle and then center coupler (1) on
the fitting
the fitting
3. Operate lever handle (3) to lubricate.
4. After lubricating turn coupler (1) at a
slight angle to release grip of the
coupler jaws from the fitting.
coupler jaws from the fitting.
!
Notice.
Failure to clean and inspect grease gun
will cause it to lose prime.
Air pockets in cartridge will cause lever
gun to lose prime.
will cause it to lose prime.
Air pockets in cartridge will cause lever
gun to lose prime.
2. Pull T-handle (8) to extend follower rod
(5) fully and slide into slot.
3. Unscrew container tube (6) from
grease gun head (10).
4. Remove empty grease cartridge (if
present) from container tube (6).
5. Remove large cap from top end of new
grease cartridge.
6. Insert new grease cartridge top end
first into container tube (6).
7. Remove pull tab from bottom end of
new grease cartridge.
8. Screw container tube (6) back onto
grease gun head (10) and tighten.
9. Pull lever handle (3) away from
container tube (6).
10. Pull back and remove follower rod (5)
from slot.
Pull tab
Grease cartridge
Large cap
6
8
5
11. Turn T-handle (8) 90° and push into
container tube (6)
12. Loosen grease gun head (10) two turns
to expel air and retighten.
3