Craftsman 47099 Manual De Usuario

FILL FROM A BULK

LUBRICANT CONTAINER

1. While holding grease gun container

tube (6), loosen grease gun head (10)
two turns.

2. Pull T-handle (8) to extend follower rod

(5) fully and slide into slot.

3. Unscrew container tube (6) from

grease gun head (10).

4. Remove empty cartridge (if present)

from container tube (6).

5. Pull T-handle (8) back and remove

follower rod (5) from slot.

6. Pack lubricant into cavity of the grease

gun head (10) and onto surface of the
follower assembly (4).

7. Insert the open end of the container

tube (6) into lubricant.

8. Pull T-handle (8) back while pushing

container tube (6) deeper into lubricant
to prevent air pockets from being
pulled into container tube (6).

9. Pull T-handle (8) to extend follower rod

(5) fully and slide into slot.

10. Thread grease gun head (10) onto filled

container tube (6).

11. Pull lever handle (3) away from

container tube (6).

12. Pull T-handle (8) back and remove

follower rod (5) from slot.

13. Turn T-handle (8) 90° and push into

container tube (6)

14. Loosen grease gun head (10) two turns

to expel air and retighten.

Notice

If grease does not come out of

coupler (1) after ten strokes of lever
handle (3), refer to Expel.Air.Pockets
section on page.6.

Notice

Failure to clean and inspect

grease gun will cause it to lose prime.
Air pockets in cartridge will cause lever
gun to lose prime.