LaCie Dupli Disc DVD 125 16x 108655 Manual

page 39

If, after powering on the LaCie Dupli Disc DVD125, the LCD display screen does not light and no images appear, check to
ensure that the power cord is firmly seated in both the drive and the power outlet.

During the main functions, if you press the Esc button during an operation, an error message will appear on the LCD display
screen. This also has the potential to cause the LaCie Dupli Disc DVD125 to hang, and you may need to power the device off
and then on.

If a read fails, an error message will appear on the LCD display screen. Try another source disc to see if the problem persists.

If the LaCie Dupli Disc DVD125 does not detect any of the drives after powering on, an error message will be shown on the
LCD display screen.

If either of the DVD drives cannot read a disc, check to ensure that the format is compatible with the drive and check to see
that the disc has not been damaged.

If any of the Control Panel buttons are not responding, switch off your Dupli Disc DVD125 and wait for 10 seconds before
switching it on again. If the Control Panel are still not responding, please contact your LaCie reseller or LaCie Technical
Support.

If you are experiencing a high failure rate while copying, please try the following steps:

• Lower the speed of the DVD+/-RW drive.
• Inspect the blank disc’s surface to ensure that it is not scratched or damaged.