TP-LINK 24-Port 10/100Mbps + 4-Port Gigabit L2 Managed Switch TL-SL3428 Hoja De Datos
Los códigos de productos
TL-SL3428
TL-SL3428/TL-SL3452
JetStream L2 Managed Switch CLI Guide
207
Parameter
multiplier —— Configure the Hold Multiplier parameter. It ranges from 2 to 10.
By default, it is 4.
Command Mode
Global Configuration Mode
Example
Specify Hold Multiplier as 5:
TL-SL3428(config)#lldp hold-multiplier 5
lldp timer
Description
The lldp timer command is used to configure the parameters about
transmission. To return to the default configuration, please use no lldp timer
command.
Syntax
lldp timer { tx-interval tx-interval | tx-delay tx-delay | reinit-delay reinit-delay |
notify-interval notify-interval | fast-count fast-count }
no lldp timer { tx-interval | tx-delay | reinit-delay | notify-interval | fast-count }
Parameter
tx-interval —— Configure the interval for the local device to transmit LLDPDU
to its neighbors. The value ranges from 5 to 32768 and the default value is 30
seconds.
tx-delay —— Configure a value from 1 to 8192 in seconds to specify the time
for the local device to transmit LLDPDU to its neighbors after changes occur so
as to prevent LLDPDU being sent frequently. By default, it is 2 seconds.
reinit-delay —— This parameter indicates the amount of delay from when
LLDP status becomes "disable" until re-initialization will be attempted. The value
ranges from 1 to 10 and the default value is 3.
notify-interval —— Specify the interval of Trap message which will be sent from
local device to network management system. The value ranges from 5 to 3600
and the default value is 5 seconds.
fast-count — — When the port's LLDP state transforms from Disable (or
Rx_Only) to Tx&Rx (or Tx_Only), the fast start mechanism will be enabled, that