Graco 3A2894F - ExactaBlend AGP Advanced Glazing Proportioner Manual De Usuario

When software is updated on the DM, the software is 
then automatically updated on all connected GCA com-
ponents. A status screen is shown while the software is 
updating to indicate the progress.

1.

Turn the power switch to OFF.

2.

Remove the DM from the bracket.

3.

Remove the token access panel.

4.

Insert and press software upgrade token (Token 
part no.16V853) firmly into the slot.

5.

Install the DM onto the bracket.

6.

Turn the power switch to ON.

NOTE: When the screen turns on, the following screen 
will appear.

7.

Remove the token.

8.

Replace the token access panel.

9.

Press

 to continue.

A status is shown while software is updating to indi-
cate progress. To prevent corrupting the software 
load, do not remove token until the status screen dis-
appears.

Update successful.

Update unsuccessful.

Update complete, no changes necessary

Update was successful/complete but one 
or more GCA modules did not have a 
CAN boot-loader, so the software was not 
updated in that module.