Cognitive Solutions A776 Manual De Usuario
Chapter 5: Programming commands
38
A776 (B780) Programming Guide
A776-PG00001 C 12/09
Select peripheral device (for multi-drop)
ASCII
ESC = n
Hexadecimal 1B 3D n
Decimal
27 61 n
Value of n:
bits 0 and 1 only:
0 = printer only
1 = printer only
2 = peripheral device only
3 = printer and peripheral device both
Default:
printer only
Selects the device to which the host computer sends data.
Related Information
When the printer is disabled by this command, it ignores transmitted data until re-enabled by same command.
Initialize printer
ASCII
ESC @
Hexadecimal 1B 40
Decimal
27 64
Default:
Character pitch:
15.6 CPI
Column width:
44 characters
Extra dot rows:
3
Character set:
Code Page 437
Printing position:
Column One
Clears the print line buffer and resets the printer to the default settings for the start-up configuration (refer to Default
settings above).
settings above).
Single-wide, single-high, non-rotated, and left-aligned characters are set, and user-defined characters or logo graphics
are cleared. (Flash memory is not affected.) Tabs reset to default. Receipt selection state is selected.
are cleared. (Flash memory is not affected.) Tabs reset to default. Receipt selection state is selected.
A776:
Slip set to 42 column pitch
B780:
Slip set to compressed pitch
Set slip paper eject length
ASCII
ESC C n
Hexadecimal 1B 43 n
Decimal
27 67 n
Value of n:
0 to 255
Exception
This command is ignored.
Set unidirectional print on impact station
ASCII
ESC U n
Hexadecimal 1B 55 n
Decimal
27 85 n
Value of n:
Only the lowest bit of n is used
0
Unidirectional printing is turned off
1
Unidirectional printing is turned on
Default of n:
0
For text printing
1
For Page Mode printing